- код:
381EHT
Mitre guillotine Morso, electric-hydraulic, model EHT
- вес нетто: kg 135 - вес брутто: kg 142
Mitre guillotine Morso, electric-hydraulic, model EHT
The Morso guillotine is used to cut both sides of the rod at 45°.
The Morso EHT model has the same technical characteristics as the basic model 381F but with some more automatic mechanisms.
The Morso Model EHT guillotine is exactly the same as the Morso EH guillotine, with the same technical data and working capacity. It's about 50% faster though.
The motor of the EHT is 1.5 kW, three-phase. The EHT machine is available in three-phase electricity only, voltage as per your requirement.
In principle the Morso EHT does the same job as the Morso F, but with the Morso EHT the job is done automatically by pressing two buttons.
If you compare the Morso EHT with a double bladed saw, you will find that:
• The cut with a saw is not as clean and precise as with the Morso EHT.
• There is no dust on the Morso EHT, as the waste from the rod is brought directly to the ground, which means that it is not necessary to buy an aspirator.
• Using a double bladed saw, there will always be approximately one centimeter of waste for the cut, but if the EHT Bit is used the waste is reduced to approximately 1 mm.
The Morso EHT is supplied with the same standard equipment as the F model, and also features:
• Extendable support bench on the left side
• Automatic stop support and pliers to fix the rod
• Measuring scale 1,500 mm with two adjustable stops. You can cut the short and long side of the frame without having to set the measurements again.
Technical data of the Morso Model EH Turbo guillotine:
• 45° oblique cut
• Cutting at various angles
• Cutting width, max. 100mm
• Cutting height, max. 180mm
• Measurement scale up to 1,500 mm
• Net weight 135 kg
• Three-phase motor 1.5 kW - 11.5 litres/min
• Working pressure 80 bar
• Power transmission 660 kg
• Tank content 8 litres